Problem when using "Remesh Deformed Configuration"

Hi,

I'm running into problems when using the "Remesh Deformed Configuration" on a solution data set that contains results from a simulation including "moving mesh" and "solid mechanics" physics. A new mesh configuration is created but this is the original geometry and not the deformed one. As suggested eariler in the forum I've tried switching the order of the two physics in the model tree, although with the same result.

I've created a simple file to illustrate this problem and would be grateful with any ideas what causes this. I've seen in the forum that other people as well have encountered this problem.

Thanks in advance,
Wiktor