There are 3D plasma unit model, some results were obtained.
Namely, the temperature distribution and melt boundary.
However, the melting process itself, I can not simulate.
To install the contents melted and flowed from it.
I do not understand how this can be done.
But I know that to do it in the program as possible.
Please tell me how to do this task,
to the melting process was clearly visible.
It is necessary that the solid into the plasma unit to melt and after a while came out of it. Next it was filled again and again melted and flowed.
Namely, the temperature distribution and melt boundary.
However, the melting process itself, I can not simulate.
To install the contents melted and flowed from it.
I do not understand how this can be done.
But I know that to do it in the program as possible.
Please tell me how to do this task,
to the melting process was clearly visible.
It is necessary that the solid into the plasma unit to melt and after a while came out of it. Next it was filled again and again melted and flowed.